Side panels of the Body.

Overview

4-door Sedan

https://i297.photobucket.com/albums/mm219/ddgonzal/1971/103-0D.jpg Album 8075

60 Front Pillar (A-pillar) Front Pillar Lower Reinforcement 8910- Window Corner Patch 8504- 62 Windshield Pillar, inner (A-pillar) 64 Dash side (Front Pillar Lower Bracket) 65 Roof Side Rail, outer 67 Roof Side Rail, inner Roof Side Rail, rear (Van) 69 Sill Panel, outer Sill Panel, inner - See Floor side panel 71 Center Pillar, outer Center Pillar, inner Center Pillar, lock (Coupe) 73 Rear Pillar, inner (4-door sedan) Rear Pillar, outer Rear Pillar, lower outer Body Side inner panel (2-door sedan) Body Side outer panel (see #Quarter Panel) 74 Rear Wheel House, outer 76 Rear Wheel House, inner 78 Shock mounting Bracket 79 Rear Sill Closing Plate 81 Lower Trunk floor side panel

Album 20790 Album 20788 Post 498220 Post 498220 Post 498220 Post 498220

2-door Sedan - differs mainly in using Rear Panels instead of rear Pillar.

https://i297.photobucket.com/albums/mm219/ddgonzal/1971/103-0E.jpg

Coupe

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/76412-H1800.jpg Album 17736 Album 21413

Sedan Rear Wheel House

Album 26197

Rear Wheel Arch

The wheelhousing is comprised of inner and out arches.

Rear outer arch (4-door sedan)

Album 20475

On four-door sedan, the door indents intrude on the arches -- unlike two door models (including ute, coupe and 2-dr sedan). With large tires or wheels offset too close to the outside of the car it can rub against this indentation when going over bumps, especially with a lowered sedan.

Here is the place most likely to rub -- but on the inside:

Upload click to view Upload click to view

To mitigate this rubbing, use a hammer to modify the sheet metal. Oan had 225 rear tyres on his sedan, and at first they rubbed on the rear arch. He used a hammer to mod the inner arch. It all depends on the wheel offset - even 185s will rub with the wrong wheel offset, but no rubbing at all with other offsets.

Take a ball peen hammer and start at the rear end of the bump where it is small. With lots of hammering and some finesse you can invert the raised area and gain quite a bit of tire room. Just takes time and makes lots of noise.

Upload click to view

Sill

Sill is the lower plate of the door opening. Also known as the rocker panel. Sills differ for each body style. It also has the front Jack locating notch stamped in it. Sedan sills additionally have a notch for the rear Jack location.

LONG SILLS - goes back to wheel housing * H10 4-door Sedan, 4-door Van * H12 2-door Sedan, 2-door Van

MEDIUM LENGTH - about 6" shorter than Van/Sedan * H18 Coupe

SHORT SILL - 150mm shorter than Coupe * G12 Truck > G10 to 8503

Upload click to view

Ute sills

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/G6411-G1200a.jpg

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/G6411-G1200b.jpg

2-door Sedan sills

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/SILLSa.jpg

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/SILLS.jpg

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/SILLSb.jpg

Coupe - 76412-H1800 < G6412-H1800 (pre-drilled for the stainless Moulding#Rocker_Pane)

Datsun 1000 (B10) sill 4-door RH

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/76402-24800_c.jpg https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/76402-24800_a.jpg https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/76402-24800_b.jpg

New Sills

Genunine Nissan

BProjects

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/76412-H1800d.jpg

Aftermarket reproduction

Automotive Panel Craft (A.P.C.) APC eBay Store

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/apc_sill_a.jpg https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/apc_sill_b.jpg https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/apc_sill_c.jpg

Forward end of sill butts against the A-pillar:

https://i297.photobucket.com/albums/mm219/ddgonzal/wiki/IMG_5892.jpg Album 9366

Sill Repair

Album 10245 Album 10244 Album 10232

^POST Ed's 81 Datsun 1200 ute build

https://img.photobucket.com/albums/v128/Ed74mnd/Datsun%201200/IMG_3557.jpg https://img.photobucket.com/albums/v128/Ed74mnd/Datsun%201200/IMG_3563.jpg https://img.photobucket.com/albums/v128/Ed74mnd/Datsun%201200/IMG_3564.jpg

Make your own sheet metal brake:

https://img.photobucket.com/albums/v128/Ed74mnd/Datsun%201200/IMG_2665.jpg

^POST 3J Improved Production coupe

^POST Rob's CA18DET 1200 UTE - Lower end of A-piller

https://img.photobucket.com/albums/x448/RSR100/IMG_0647.jpg

^POST Rob's - sill slips into this and is then spot-welded

https://img.photobucket.com/albums/x448/RSR100/IMG_0648.jpg

^POST Rob's

http://i1182.photobucket.com/albums/x448/RSR100/IMG_0741.jpg☁

G6411-G1200 Sunny Truck

https://i297.photobucket.com/albums/mm219/ddgonzal/Datsun%201200/wiki/G6411-G1200c.jpg

Quarter Panel

Sedan quarter panel, or as Datsun calls it "rear fender"

Album 19072 Album 19073 Album 15733

78101-H1900 ASSY-FENDER REAR LH 2DR SEDAN USA 78101-H1200 ASS'Y-FENDER,rear (L.H.) 2 door JAPAN H1000 (from '72-3) 78101-H1055 ASS'Y-FENDER,rear (L.H.) 4 door JAPAN 78101-H2825 PANEL ASS'Y-fender, rear (L.H.) PB110 Sedan Airbox (attaches to inside of upper quarter) H10 4-door sedan H12 2-door sedan

Coupe quarter panel

Album 17732 Album 17724

Coupe quarter panel 78111-H1955 ASSY-FENDER REAR LH COUPE 78111-H1905 <> 78111-H1955 USA 78111-H1800 ASS'Y-FENDER,rear <> 78111-H1850 < 78111-H1851 JAPAN

Van quarter panel 78101-H1450 ASS'Y-FENDER, rear (L.H.) < 78101-H1455 JAPAN

Truck Rear Side

Long Body has 5 hooks per side

Short Body has 4 hooks per side

Red parts differ Long Body versus Short Body

Album 23216

76304-G1025 PANEL ASS'Y-body side outer (R.H.) 76305-G1025 PANEL ASS'Y-body side outer (L.H.) 1 76306-G1050 PANEL ASS'Y-body side outer rear (R.H.) with gas filler lid Album 3326 2 76307-G1050 PANEL ASS'Y-body side outer rear (L.H.) 3 76310-G1050 PANEL ASS'Y-body side outer rear end (R.H.) 3 76311-G1050 PANEL ASS'Y-body side outer rear end (L.H.) 4 90510-G1000 HOOK ASS'Y-rear gate (R.H.) 4 90511-G1000 HOOK ASS'Y-rear gate (L.H.) 5 75310-G1000 REINFORCEMENT ASS'Y-anchorage upper (R.H.) 5 75311-G1000 REINFORCEMENT ASS'Y-anchorage upper (L.H.) 6 76500-G1000 PILLAR ASS'Y-center (R.H.) 6 76501-G1000 PILLAR ASS'Y-center (L.H.) 7 76308-G1050 PANEL ASS'Y-body side outer upper (R.H.) * superceded 76308 G1000 8 76309-G1050 PANEL ASS'Y-body side outer upper (L.H.) * superceded 76309-G1000 9 76320-G1027 PANEL ASS'Y-body side inner rear (R.H.) 10 76321-G1026 PANEL ASS'Y-body side inner rear (L.H.) * superceded 76321 G1025 superceded 76320-G1026 ** replaced 76320-G1025 https://img.photobucket.com/albums/v128/Ed74mnd/Datsun%201200/IMG_3525.jpg 11 93332-G1000 HOOK-rope (8) 12 79200-G1000 PANEL ASS'Y-back inside (R.H.) 12 79201-G1000 PANEL ASS'Y-back inside (L.H.) 13 76907-G1000 COVER-body side (R.H.) [3-bar] 13 76908-G1000 COVER-body side (L.H.) [3-bar] Album click to view Album click to view * 14 96706-G1000 GROMMET-screw (12 per side) * 15 08530-51612 SCREW (12 per side)

Long Body - same as above except:

76304-G1425 PANEL ASS'Y-body side outer (R.H.) LB 76305-G1425 PANEL ASS'Y-body side outer (L.H.) LB 1 76306-G1450 PANEL ASS'Y-body side outer rear (R.H.) * includes gas filler lid 2 76307-G1400 PANEL ASS'Y-body side outer rear (L.H.) 9 76320-G1425 PANEL ASS'Y-body side inner rear (R.H.) 10 76321-G1425 PANEL ASS'Y-body side inner rear (L.H.) 11 93332-G1000 HOOK-rope (10) 13 76907-G1400 COVER-body side (R.H.) [4-bar] 13 76908-G1400 COVER-body side (L.H.) [4-bar]